MaxTech NXP-16 Manual de usuario descargar pdf (Pagina 11)

Product data sheet Rev. 04 — 17 March 2009 11 of 29

NXP Semiconductors

PCA9532

16-bit I

C-bus LED dimmer

7.3 Acknowledge

The number of data bytes transferred between the START and the STOP conditions from

transmitter to receiver is not limited. Each byte of eight bits is followed by one

acknowledge bit. The acknowledge bit is a HIGH level put on the bus by the transmitter,

whereas the master generates an extra acknowledge related clock pulse.

A slave receiver which is addressed must generate an acknowledge after the reception of

each byte. Also a master must generate an acknowledge after the reception of each byte

that has been clocked out of the slave transmitter. The device that acknowledges has to

pull down the SDA line during the acknowledge clock pulse, so that the SDA line is stable

LOW during the HIGH period of the acknowledge related clock pulse; set-up and hold

times must be taken into account.

A master receiver must signal an end of data to the transmitter by not generating an

acknowledge on the last byte that has been clocked out of the slave. In this event, the

transmitter must leave the data line HIGH to enable the master to generate a STOP

condition.

Fig 9. System conﬁguration

002aaa966

MASTER

TRANSMITTER/

RECEIVER

SLAVE

RECEIVER

SLAVE

TRANSMITTER/

RECEIVER

MASTER

TRANSMITTER

MASTER

TRANSMITTER/

RECEIVER

SDA

SCL

C-BUS

MULTIPLEXER

SLAVE

Fig 10. Acknowledgement on the I

C-bus

002aaa987

START

condition

9821

clock pulse for

acknowledgement

not acknowledge

acknowledge

data output

by transmitter

data output

by receiver

SCL from master

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 28 29

Comentarios a estos manuales

Vikivtx 04 Jan 2024 | 11:57:49

urenrjrjkvnm

Serzicp 11 Jan 2024 | 20:01:40

coin

MaxTech NXP-16 Manual de usuario Pagina 11

Comentarios a estos manuales

Relacionado con productos y manuales para Redes MaxTech NXP-16